BatchLabel Bench
← Barcode generator

Print Barcode Labels on A4 or US Letter

Use a plain-paper test sheet to check the grid and offsets before you load label stock.

Compare the layout with your labels

The US Letter preset prints 30 labels in a 3 × 10 grid. Each label is 66.675 × 25.4 mm (2.625 × 1 in). The A4 preset prints 24 labels in a 3 × 8 grid, with 64 × 33.9 mm labels. Measure several rows and columns of your stock as well as the sheet margins before choosing the preset.

Preset Side margin Top margin Column gap
US Letter, 30-up 4.7625 mm 12.7 mm 3.175 mm
A4, 24-up 6 mm 12.9 mm 3 mm

Both presets have no vertical gaps between rows. Use different stock if your grid has another pitch or a different number of labels.

Set the scale and print a test

  1. Open the barcode generator and choose the matching sheet.
  2. Expand Print alignment and choose Print scale check.
  3. Choose the matching paper size and 100% or Actual size in the browser dialog. Turn off headers and footers, use portrait, and avoid Fit to page.
  4. Use a ruler to check that the horizontal marks are 100 mm apart and the vertical marks are 50 mm apart. If the distances are off, fix the paper size and scale before changing offsets.
  5. Use Print alignment test to print the grid. Hold the plain-paper grid against the label stock to check all four corners.

Fix an offset or a scaling problem

If every label is too far left by the same amount, use a positive Move right offset. If they are all too low, use a negative Move down offset. Small changes of 0.5 mm make it easier to compare test sheets. Each offset can be between -5 and 5 mm. Leave an offset blank to use zero.

If the first row aligns but the last row drifts, inspect print scale and the gap between rows before changing the offset. An offset moves the whole grid and cannot fix incorrect spacing. Some printers cannot print near the edges of the sheet, so use a test sheet to check the first and last columns.

Diagnose the first and last rows

Save the batch as a PDF when sending it to another printer. In the PDF reader, select the same paper and print at actual size again. Adobe's print size guide explains the difference between actual size and scaling to fit.

Before running the whole batch, scan a printed sample with the reader you use for inventory. Keep the white area around the barcode clear; cutting too close to the bars can make reads unreliable.

Save a setup for the next run

Open Saved print setups on the generator. Give your current paper size and offsets a name, such as Stockroom Letter, and click Save setup. To reuse it, select it and choose Apply. Saving with the same name replaces those values. Each browser can store up to 12 setups. Applying a setup leaves your batch contents and barcode format alone.